Varimixer W60P Bedienungsanleitung

THE PROGRAMMABLECONTROL SYSTEMMK-IV User’s Manual

Control Data for Program 26Program 26 contains the control data required by the computer to operate. This data differs frommodel to model. To access

ADIn the electronics fail.It is possible to bypass the control system if the electronics fail.Please note, when the system is bypassed, the safety dev

E:401 E:301E:201Error CodesA error in the mixer will trigger an ERROR code in the time display. See the chart below for anexplanation of error codes a

E:301 There is no signal from the speed pickup (hall effect sensor). To correct this error:1) Check that the sensor (D) is centered direct

E:4:01 The values in program 26 steps 7, 8 and 9 are missing or incorrect.To correct this error:

MAINTENANCE AND ADJUSTMENTSComputer Control2 Fuses: 8 Amp6.3 x 32 MMP.N. 20E-418.1Power Supply1 Fuse:1.5 Amp6.3 x 32 MMP.N. 20E-418Fuse data and compo

Models W30, W40, W40P, W60,W60PBowl adjustmentsW30 = 6 3/8”W40 = 6 3/8”W60 = 7”14

Bowl adjustmentsModels W80, W100, W150NW80 = 9 1/8”W100 = 11 5/8”W150 = 11 7/8”15

LubricationWhite Lithium Grease (IE Lubriplate)Nye Fluorocarbon Gel 868VHOrder from authorized service agentPart number: WHITE GREASE16

Belt adjustments17NEVER move the base for motor (R)(in the oblongholes) , this is a factory setting and is NOT used totighten the belts.If the entire

Belt Exchange181. Loosen Bolt (J) and remove washers (H).22. Remove cotterpin (T) and dowel pin (E) from servo linkage.2 .3. Remove vari drive belt (A

Belt Exchange19

Adjustment of low and high speed microswitches.20

Adjustment of low and high speed microswitches.21

Speed Servo SystemFigure Number DescriptionW30, W40 , W40PW80, W100 , W1501...Sensor...30E-500M...

Speed Servo System23

Power SupplyFigure Number Description All Models1...Transformer...60

Power Supply123456789111025

26

27

General descriptionsMODESThe system contains six different modes:1. MANUAL MODE: The mode when the mixer is operated like a man-ual controlled mixer.

Power Supply Wiring Diagram1.5 Amp28

5489 Campus DriveShreveport LA 71129(800) 222-1138(318) 635-3131 Fax

The KeypadThe Keypad is used for entering data to the system. ITEM FUNCTION EXPLANATION1. Progra

6. Enter Used for stepping through a program.7. CLR 8. Speed up

How to run the mixer manually.SPEED Mode.Enter the speed desired.PushEnter the time desired.PushPushHow to input a program.A flashing display indicate

To program a recipe.PushPushEnter the speed desired.“HOLD FOR 3 SECONDS”Repeat this process for as many as 9 steps per program, after the 9th step , t

To run a programmed recipe.PushPushEnter the Program number.PushAfter the ENTER key has been pushed, the data in step 1 will be displayed along with t

To enter “FIXED MODE”PushPush “99”“HOLD FOR 3 SECONDS”PushPush “1 2 3 4”PushPush the program number.PushTo exit “FIXED MODE”Push“HOLD FOR 3 SECONDS”Pu