Varimixer W40P Bedienungsanleitung PDF herunterladen (Seite 6)

OPERATION OF THE MIXER:

A) Open the bowl screen and place the bowl in the bowl

arms. Note: The bowl arms must be in lowest position and

the bowl must be pushed all the way into the bowl

arms.(Fig.3).

B) Place the mixing tool in the bayonet shaft. The pin on

the tool must be turned into the bayonet hole (fig.2).

C) The bowl is raised to working position by turn of the

button for bowl lift (fig.1), ensure that the bowl is placed

correctly. Close the bowl screen. If the mixer is equipped

with a timer, set the mixing time required by turning the

timer (fig 1) clockwise. The mixer will stop automatically,

when the time runs out. When the mixer has timed out, the

"procedure for starting after emergency stop" is used

before the mixer is re-started.

D) Start the mixer by pressing the green start button

(fig.1)

The mixer will only start when the bowl is in "up"position,

the bowl screen is closed,and the timer is set to time or

"hold".

E) Turn the speed selector lever (fig. 4) to the rear until

the required speed has been obtained, (notice the recom-

mended maximum speeds on page 3).

F) Before the mixer is stopped, the speed selector lever

must be moved back to lowest speed (fig.4).

G) Stop the mixer by pressing the red stop button (fig.1)

PROCEDURE FOR STARTING AFTER EMERGENCY

STOP:

1) This procedure must be used in cases where the mixer

has been interrupted in high speed.

2) Lower the bowl and remove the tool from the bayonet.

3) Raise the bowl arms, either empty or with the bowl.

4) Close the safety guard, start the mixer and move

the speed selector lever back to lowest speed. Switch off

the mixer. Now the mixer can be started as usual.

OVERLOAD

Do not overload the mixer. Sticky and heavy doughs may

reduce the capacity of the bowl by 75%. The capacity is

further reduced if the speed of the mixing tool is increased

beyond recommended values or if an incorrect mixing tool

is used. Large lumps of fat or cooled ingredients MUST be

cut into small parts before they are placed into the bowl or

damage can occur to the mixing tool(s).

1 2 3 4 5 6 7 8 9 10 11 ... 54 55

Kommentare zu diesen Handbüchern

Keine Kommentare

Varimixer W40P Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mixer Varimixer W40P